Need help?Do you have a question about the Ehong EH-MC17 and is the answer not in the manual?
General| Brand | Ehong |
|---|---|
| Model | EH-MC17 |
| Category | Control Unit |
| Language | English |
Details the default UART configuration settings for the module.
Explains the general syntax for AT commands and indicators.
Defines the meaning of syntax components like AT+, CMD, IDC, =, and ,.
Provides practical examples of AT command usage and module responses.
Resets the Bluetooth module to its default state.
Queries the Bluetooth module's firmware version.
Queries or configures the module's name.
Queries or configures the module's Bluetooth address.
Queries or configures the module's pairing code.
Queries or configures the UART baud rate.
Queries or configures the broadcasting mode.
Queries or configures the TX power level.
Queries or configures broadcast data for beacons.
Queries or configures response data for beacons.
Queries or configures the module's master/slave mode.
Queries or configures the 2M schema.
Enters disconnected mode for power saving.
Queries or configures the module's pairing mode.
Queries or configures UART flow control.
Queries or configures BTFC flow control.
Restores default settings and restarts the module.
Searches for Bluetooth devices in master mode.
Stops searching for Bluetooth devices.
Searches for Bluetooth address by number query.
Connects to a remote Bluetooth device.
Enters the module into RF test mode.
Indicates successful adoption of a command by the module.
Indicates an error detected in the sent command.
To Next Page