Ei Electronics Ei450 - System Diagnostics; Remote Testing - Walk round test (optional)

The system diagnostic features are intended to assist professional installation
and maintenance personal to install, commission and maintain the RadioLINK
fire and control systems utilising the Ei450 i-controller.
These features are not intended for the home owner / tenant and should only be
used by personnel described above.
The alarm identification test only works with some RadioLINK Alarms. To check
the current list of Alarms supported or for additional maintenance and diagnostic
information please go to this webpage
ZZZHLHOHFWURQLFVFRPDUWLFOHVHLPHPRU\LGSURGXFWVKWPO
Alternatively use your smart phone to capture this QR code and download the
page immediately.
Remove the Ei450 controller from its cradle. If the unit has been tamper
proofed you will need to release the latch with a screwdriver.
6\VWHP'LDJQRVWLFV
:$51,1*
5HPRWH7HVWLQJ²:DONURXQGWHVWRSWLRQDO
Fire / CO Alarm Controller
17