On entering the system diagnostic mode the TEST segment will
flash green inviting you to press the button.
When you press the button the segment will turn blue and all the
Alarms in the system will sound for 2 minutes.
This will allow you to walk around the house and verify that each
individual Alarm is sounding.
The test will automatically cease after 2 minutes or if the button
is pressed again.
If an alarm memory has been set the TEST and MEMORY
segments will flash green alternatively after entering the system
diagnostics mode.
While the MEMORY segment is illuminated press the button until
the MEMORY segment goes blue.
7ZRPLQXWH/RQJ7HVW
$ODUP,GHQWLILFDWLRQ7HVW
19
Fire / CO Alarm Controller
Fire / CO Alarm Controller
Fire / CO Alarm Controller
Fire / CO Alarm Controller
To Next Page
Loading...