EIBENSTOCK EBM 300/3 P

Questions and Answers

A
Andrew GregoryAug 8, 2025
What to do if my EIBENSTOCK EBM 300/3 P motor cuts off?
- D
  Daniel ChandlerAug 8, 2025
  If the motor of your EIBENSTOCK Power Tool cuts off, it could be due to several reasons. The tool may be stopping because it is not being guided in a straight manner; ensure you lead the tool straight. Alternatively, the tool might be overheating, triggering the motor's overload protection; in this case, discharge the tool and restart it by pressing the switch. Lastly, worn-out carbon brushes could be the cause; if this is the case, have both brushes replaced with original brushes by an electrical specialist.
O
Oscar ThompsonAug 14, 2025
Why EIBENSTOCK EBM 300/3 P Power Tool machine does not work?
- N
  Nathaniel GarciaAug 14, 2025
  If your EIBENSTOCK Power Tool isn't working, it could be due to a few reasons: * The mains current supply might be interrupted. To check, plug in another electric appliance to see if it functions. * The line cord or plug might be damaged. In this case, have it checked by an electric specialist and replaced if necessary. * The switch could be damaged. Have it checked by an electric specialist and replaced if needed. * The PRCD-switch might be off. If so, press RESET to switch it on.
C
Christina CampbellAug 20, 2025
What to do if drilling speed is too slow on my EIBENSTOCK Power Tool?
- J
  Jennifer SchroederAug 20, 2025
  If the drilling speed of your EIBENSTOCK Power Tool is too slow, consider the following: 1. The water pressure or water flow rate might be too high. Try regulating the water quantity. 2. The drill bit could be damaged. Check it and replace if necessary. 3. The gearbox might be damaged. Have the tool repaired by an authorized service workshop. 4. The drill bit might be blunt. Sharpen it with a sharpening block while using the flush.
N
Nathan RodriguezAug 27, 2025
What to do if motor runs but drill bit does not rotate on EIBENSTOCK EBM 300/3 P?
- N
  Nathaniel TrujilloAug 27, 2025
  If the motor of your EIBENSTOCK Power Tool runs, but the drill bit does not rotate, the gearbox might be damaged. Have the tool repaired by an authorized service workshop.
J
Jose GibsonSep 2, 2025
What to do if water drops out of the gearbox housing of EIBENSTOCK EBM 300/3 P Power Tool?
- E
  Eric HintonSep 2, 2025
  If water is leaking from the gearbox housing of your EIBENSTOCK Power Tool, it suggests that the shaft sealing rings are damaged. To resolve this, have the tool repaired by an authorized service workshop.