Eilon Engineering Ltd. RON 2501 NG Operating Manual 26
9. Error Table
Error # Meaning
01 Memory failure.
03 Calibration; Load value above capacity.
04 Not legal zero command; Value above 30% of capacity.
05 Not legal zero command; Unstable load value for zeroing.
07 Totalizer summed-up value overflow.
08 Data logger. Fully logged. No additional memory volume left.
10 Data logger. This option does not exist in this system.
15 Real Time Clock (RTC): This option is not included in this system.
20 RS-232, set point/s options are not included in this system.
25/26 ON/OFF command failed. Try again.
31 Totalizer. The system did not have a zero load before the last loading.
32 Totalizer. Trying to sum-up “zero” load.
33 Totalizer. Trying to sum-up an overload.
34 Totalizer. Trying to sum-up NET & GROSS loads.
49 Totalizer. This option is not included in this system.
50 More than one key pressed. More than 3 seconds.
51-59 A key is pressed more than 3 sec.
60 Display overflowed.
80 Failure in type #.
81 3001 Rx data received erratically.
100 3001 Decimal point wrong.
102 Data logger appears in the menu, but actually does not exist.
104 Baud rate is not according the standard values.
N.G.
To Next Page
Loading...
