6
GB
USE
The swing sander is designed for the sanding and
polishing of wood, iron, plastic and similar materials
when using the correct sanding paper.
Description
1. Sanding disk
2. Housing
3. Lock button
4. On/Off switch
5. Dust bag socket
6. Power cable
7. Dust bag
8. Locking nut for the auxiliary handle
9. Screw for the auxiliary handle
Please read the operating instructions carefully
and observe the safety regulations at all costs.
Keep the operating instructions together with the
swing sander.
Technical data
Voltage: 230 V ~ 50 Hz
Power rating: 105 W
Sanding surface: 140 x 140 x 80 mm
Disk size: 140 x 140 x 80 mm
Oscillations per minute: 11.000
Safety insulated
Sound pressure level LPA 70 dB(A)
Sound power level LWA 80 dB(A)
Vibration a
w
6,86 m/s
2
Weight 0,92 kg
Items enclosed
BSS 105 sander
Dust bag
10 x sanding disk
General safety regulations
Always remove the plug from the socket before
doing any work on the machine (cleaning,
changing sanding disks etc.).
For the sake of your health, always wear a dust
mask and goggles when sanding.
Before you begin work, make sure the workpiece
cannot slip.
It is in your own interests to keep the machine
clean at all times and to check it for damage after
each use.
The noise level at the place of work may exceed
85 dB (A), in which case the user will require ear
muffs.
Vibration measured in the handle according
EN 50144-1.
Maintenance
Keep the eccentric sander clean at all times.
Never use any caustic agents to clean the plastic
parts.
Important!
In the interests of your health, always use the dust bag!
Attaching the dust bag
Dust is extracted straight through the sanding disk
To Next Page
Loading...