EasyManua.ls Logo

EINHELL BG-SP 250 - User Manual

EINHELL BG-SP 250
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Bedienungsanleitung
Tauchpumpe
t
Operating Instructions
Submersible Pump
p
Mode d’emploi
Pompe submersible
C
Istruzioni per l’uso
Pompa sommersa
lL
Betjeningsvejledning
Dykpumpe
A
Használati utasítás
Bemerülő szivattyú
Bf
Upute za uporabu
Podvodna pumpa
4
Uputstva za upotrebu
Podvodna pumpa
Art.-Nr.: 41.702.91 I.-Nr.: 01018
BG-SP
250
Anleitung_BG_SP_250_SPK1:_ 23.06.2008 11:06 Uhr Seite 1

Table of Contents

Questions and Answers

  • C
    Colton KimAug 12, 2025
    Why does my EINHELL BG-SP 250 stop after starting?
    • A
      Autumn SerranoAug 12, 2025
      Your EINHELL Power Pump might be switching off shortly after starting due to a couple of reasons. It's possible that the motor circuit-breaker is being tripped by excessive water contamination, so you should unplug the power and clean both the equipment and the shaft. Alternatively, the water temperature may be too high, causing the motor circuit-breaker to activate. Make sure the water temperature doesn't exceed 35°C.
  • M
    Miranda ThompsonAug 19, 2025
    What to do if my EINHELL BG-SP 250 Power Pump is not pumping water?
    • B
      Brett HigginsAug 19, 2025
      If your EINHELL Power Pump isn't pumping water, there are a couple of things to check: * The intake sieve might be clogged. Clean it with a water jet. * The discharge hose could be kinked. Make sure to unkink the hose.
  • W
    williamscarolAug 27, 2025
    How to fix insufficient pumping rate in my EINHELL Power Pump?
    • M
      martinezangelaAug 27, 2025
      If your EINHELL Power Pump has an insufficient pumping rate, it could be due to a couple of reasons. The intake sieve might be clogged, so try cleaning it. Also, heavily contaminated or abrasive water impurities can reduce performance. In this case, clean the equipment and replace any worn parts.
  • C
    Charles DeanSep 3, 2025
    Why won't my EINHELL BG-SP 250 start?
    • K
      Kimberly SheltonSep 4, 2025
      If your EINHELL Power Pump isn't starting, there are a couple of things to check. First, make sure the power supply is properly connected. If it is, the floating switch may not be triggering. Try raising the position of the floating switch.

EINHELL BG-SP 250 Specifications

General IconGeneral
Power250 W
Max Delivery Rate6000 L/h
Max Immersion Depth5 m
Max Grain Size5 mm
Min Suction Level40 mm
Water Temperature Max35 °C
Hose ConnectionG1 (33.3 mm)
Power Cord10 m
Voltage230 V
Frequency50 Hz
Max Flow Rate6000 L/h