9
GB
Using the flexible shaft (Fig. 4)
앬 Unscrew the ring from the front of the machine
앬 Fit the flexible shaft to the multi-tool by inserting
the internal shaft (1) into the chuck (2) and
tightening it.
앬 Now tighten the ring (3) on the multi-tool.
5. Maintenance and cleaning
To prolong the life of your tool you should always
clean it carefully after use. Do not use any solvents
for cleaning purposes.
Important!
To rule out risk of injury to persons and damage
to property, never clean the product in running
water and certainly never clean it under high
pressure.
6. Accessories (Fig. 3)
1 Grinding head
2 Grinding head caps
3 HSS drill bit
4 Whetstone
5 Clamping spindle for grinding and cut-off wheels
6 Cut-off wheel
7 Sanding disk
8 Grinding wheel
9 Holder for felt polishing pad
10 Felt polishing disks
11 Grinding pins
12 Engraving pins
13 Sleeve
14 Brushes
15 Check key
16 Cutter
Cut-off wheels: For cutting metal and plastic.
Mount the cut-off wheel on the
clamping spindle.
Engraving pins: For engraving decorations and
identification marks in glass and
metal
Grinding pins: Available in a variety of grinding
head shapes. For grinding and
deburring metal and plastic.
HZ drill bit: For drilling in nonferrous metal,
wood, plastic and printed circuit-
boards
Grinding wheel: For cleaning and sharpening
knives and tools. Mount the
grinding wheel on the clamping
spindle.
Sanding disk: For sanding and smoothing
wood and plastic.
Polishing felt: For polishing brass, tin, copper,
etc. Can also be used in
conjunction with polishing paste.
Whetstone: For sharpening tools.
Brushes: For cleaning stone, metal,
aluminium, etc.
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
앬 Type of machine
앬 Article number of the machine
앬 Identification number of the machine
앬 Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
To Next Page
Loading...
Need help?
General
