10
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
2. Layout and items supplied (Fig. 1-2)
1. Handle
2. Accessory mount
3. Swing-out push bar
4. Carry handle
5. High-pressure cleaner
6. Power cable
7. Foam nozzle
8. Mains plug
9. Connector for high-pressure hose to device
10. Holder for gun/accessories
11. Transportation wheels
12. ON/OFF switch
13. Water inlet connector
14. Gun
15. Cleaning agent tank
16. Lance point / wide cone
17. Lance with rotating nozzle
18. High pressure hose
19. Water intake filter (Fig. 11)
A. Wire
3. Proper use
The high-pressure cleaner is designed to clean
vehicles, machines, buildings, facades, etc. in the
private sector.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Mains voltage: 230-240 V ~ 50 Hz
Power input: 2000 W
Working pressure: 9 MPa (90 bar)
Operating pressure (EW bar):
max. 16 MPa (160 bar)
Delivery rate: 6 l/min
Max. water inlet pressure: 0.4 MPa (4 bar)
Totally insulated: II/쏾
Sound pressure level L
pA
: 75 dB
Sound power level L
WA
: 97 dB
Weight: 10 kg
5. Before putting the machine into
operation
5.1 Correctly using the device
쎲 The high-pressure cleaner must be set on a
level, stable surface..
쎲 It is recommended that you maintain the correct
operating position every time you use the
machine by placing one hand on the pistol and
the other on the lance.
쎲 Never direct the water jet toward electrical lines
or the machine itself.
쎲 It is normal for the pump to leak a little; this is
necessary to avoid damage to the pump when it
is at a standstill.
쎲 Never use the equipment in potentially explosive
areas under any circumstances!
쎲 The operating temperature must be between +5
and + 60°C.
쎲 Do not cover or modify the lance or the spray
nozzles in any way.
쎲 The high-pressure cleaner is designed to be
used with cold or lukewarm water (max. 60°C);
higher temperatures can damage the pump.
쎲 Do not use water that is dirty, gritty or contains
any chemical products, as these could impair
operation and shorten the life of the equipment.
To Next Page
Loading...