Why does my EINHELL GC-BC 25 AS smoke so much?
Excessive smoke from your EINHELL Trimmer could be due to an incorrect fuel mix. Ensure you are using the correct fuel mix as specified in the fuel mixing table. If the problem continues, the carburetor setting might be off, requiring attention from an authorized customer service outlet.
What to do if my EINHELL GC-BC 25 AS Trimmer starts but has no power?
If your EINHELL Trimmer starts but lacks full power, first check the choke lever setting and set it to the correct position. Also, a soiled air filter could be the cause, so try cleaning it. If neither of these steps helps, the carburetor setting may be incorrect, and you should contact an authorized customer service outlet.
Why EINHELL GC-BC 25 AS engine does not run smoothly?
If the engine of your EINHELL Trimmer isn't running smoothly, it could be due to an incorrect electrode gap on the spark plug. Clean the spark plug and adjust the electrode gap, or replace it with a new one. If the issue persists, the carburetor setting may be incorrect; in this case, contact an authorized customer service outlet.
Explains the meaning of warning signs displayed on the equipment.
Provides crucial safety advice and precautions for operating the equipment.
Details preparatory steps and checks required before starting equipment operation.
Illustrates and lists the main components and parts of the equipment.
Lists all accessories and parts supplied with the main equipment unit.
Describes the intended and safe application of the petrol power scythe.
Presents technical data regarding the acoustic pressure and vibration emissions.
Guides on fitting the steady grip and long handle for proper ergonomics.
Instructions for installing blade guards, cutting blade, and line spool.
Instructions on adjusting the equipment's cutting height for optimal use.
Lists essential checks to perform on the equipment before starting the engine.
Details the correct fuel and oil mixture ratio and procedure for the engine.
Provides step-by-step instructions for starting the engine from a cold state.
Provides step-by-step instructions for starting the engine when it is already warm.
Explains normal and emergency procedures for stopping the engine.
Offers advice for efficient and safe operation of the equipment.
Introduces various methods for cutting grass and weeds, including trimming and mowing.
Details techniques for cutting along fences, around trees, and on slopes.
Step-by-step guide for replacing the cutting line spool.
Instructions on how to maintain the sharpness of the safety hood blade.
Procedures for checking, cleaning, and maintaining the air filter.
Guidelines for checking, cleaning, and maintaining the spark plug.
Instructions for adjusting the throttle cable and setting the idling speed.
Specifies when and how to apply grease to the gear unit.
Guidelines for cleaning the equipment, long-term storage, and putting it back into operation.
Guidance on transporting the machine and information needed for ordering replacement parts.
General| Product color | Aluminium, Black, Red |
|---|---|
| Rotational speed | 7200 RPM |
| Number of strokes | 2 |
| Fuel tank capacity | 0.4 L |
| Engine displacement | 27 cm³ |
| Automatic feed spool | Yes |
| Cutting diameter (max) | 450 mm |
| Power source | Gasoline |
Weight and Dimensions| Weight | 6300 g |
|---|---|
| Package depth | 1000 mm |
| Package width | 260 mm |
| Package height | 250 mm |
| Package weight | 8300 g |
To Next Page
