EINHELL GC-ET 4025 User Manual

GBGB
- 21 -
8.2 Replacing the line spool
Important! Make sure that you pull out the
power plug before replacing the line spool!
•
Press the sides of the spool cover as shown
and remove the cover (Figure 12b).
•
Remove the empty line spool.
•
There is a spare line spool in the additional
handle. To take it out, proceed as follows:
Press the lever (Fig. 12a/Item B) in the direc-
tion of the arrow and pull the spare line spool
out of the holder.
•
Thread the end of the line from the new line
spool through the eyelet in the spool mount
(Fig. 12c) and allow approx. 10 cm of line to
project.
•
Fit the spool cover back in the spool mount.
•
When you start the equipment again the line
will be cut to the perfect length automatically.
Important! Bits of the nylon line could cause
injury when ung out!
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Spare line spool Art. no.: 34.056.90
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council oces.
10. Storage
Store the equipment and accessories out of
children’s reach in a dark and dry place at above
freezing temperature. The ideal storage tempe-
rature is between 5 and 30 °C. Store the electric
tool in its original packaging.
11. Troubleshooting
The machine will not work:
Check that the power cable is connected properly
and check the mains fuses.
If the machine will not work despite the voltage
supply being OK, send it to the specied after-
sales service address.
Anl_GC_ET_4025_4526_SPK7.indb 21 18.12.13 11:40

EINHELL GC-ET 4025 Specifications

General

Brand	EINHELL
Model	GC-ET 4025
Category	Trimmer
Language	English