- 13 -
6. Normal Operation
6.1 Power On/O
Press Button „
“ for 2 seconds then the display will power on, and the controller will power on at the
same time. With display on, Press Button „
“ for 2 seconds to turn o power system of the e-bike. With
the display o, the display and controller shut down. The leakage current of display on shutdown state is
less than 1μA. When the e-bike is without using for 10 minutes, the display will shut down itself automa-
tically.
6.2 Speed Display (Real-time speed/Average speed/ Max speed)
After starting up the display, default show is real-time speed. Long press both „
“ and „+“ buttons for
2s to change the indicated information in sequence as below:
Real-time Speed (Km/h) → Average Speed (Km/h) → Max Speed (Km/h).
6.3 Distance Display (Trip Distance/ Total Distance)
After starting up the display, default show is Real-time speed. Press button „
“ to change the indicated
information in sequence as below: Trip Distance (km) →Total Distance (km). Long press the two buttons
„
“ and „-“ , the trip distance will be reset to zero.
Trip Distance (TRIP) → Total Distance (ODO)
6.4 Turn on/o Backlight
Press button „+“ for 2 seconds to turn on the backlight of the display, the headlight will be on at the same
time. Hold Button „+“ for 2 seconds again, backlight is o.
Turn on Backlight
Anl_Tacho_SPK7.indb 13 24.08.2018 12:18:15
To Next Page
Loading...