GB
22
How to eliminate technical faults
Please read the safety information on page 16 and 17
Fault Cause Remedy
Motor does not run No electricity Check socket, cable and plug.
Damaged cable: Have repaired by
Customer Service. It is prohibited to patch
the cable with insulating tape.
Damaged switches have to be replaced by
a Customer Service workshop.
Chain brake See section 16 and 17 „Chain brake“ and
„Releasing the chain brake“.
Chain does not move Chain brake Check the chain brake, release if
necesary.
Poor cutting performance Blunt chain Chain wrongly fitted
Chain tension Sharpen the chain
Check that the chain
is fitted correctly Check the chain tension
Saw works only with difficulty Chain tension Check the chain tension
Chain jumps off sword
Chain becomes hot Chain lubrication Check oil level
Chain chain lubrication
Never use tools with defective On/Off switches.
In the case of all other types of technical faults, please contact an authorized Customer Service workshop, our
Central Service Department, or your local dealer.
Anl. KSE 1435,1635,1640 31.10.2001 7:56 Uhr Seite 22
To Next Page
Loading...
