To Next PageTo Next PageWhy EINHELL LE-PM 51 S HW-T engine does not start?
If your EINHELL Lawn Mower engine doesn't start, try these steps: * Ensure the engine start/stop lever is pressed. * Check the throttle lever position (if your model has one). * Replace the spark plug if it's defective. * Refuel if the fuel tank is empty. * Actuate the fuel pump (primer) if your model has one.
What to do if EINHELL LE-PM 51 S HW-T Lawn Mower leaves lawn yellow, uneven cut?
If your EINHELL Lawn Mower isn't cutting evenly and the lawn turns yellow, it could be due to a few reasons. The blade might not be sharp enough, so try sharpening it. Also, the cutting height might be too low; adjust it to a more appropriate level. Lastly, ensure the engine speed isn't too low by setting the throttle lever to max (if your lawnmower has one).
Why EINHELL LE-PM 51 S HW-T engine does not run smoothly?
If the engine of your EINHELL Lawn Mower isn't running smoothly, the air filter might be dirty, so try cleaning it. Another potential cause is a dirty spark plug, which should also be cleaned.
What to do if EINHELL Lawn Mower grass chute is not clean?
If the grass chute of your EINHELL Lawn Mower isn't clean, it could be because the engine speed is too low. Try setting the throttle lever to maximum. It might also be that the cutting height is too small, so set it properly. A worn blade can also cause this issue, so replace the blade if necessary. Finally, check if the grass bag is clogged and empty it if it is.
How to fix EINHELL LE-PM 51 S HW-T Lawn Mower that vibrates intensively?
If your EINHELL Lawn Mower doesn't operate smoothly and vibrates intensively, check if any bolts are loose and tighten them. Also, make sure the blade attachment is secure. If the blade is imbalanced, consider replacing it.
General| Model | LE-PM 51 S HW-T |
|---|---|
| Cutting Width | 51 cm |
| Handle | Ergonomic, foldable |
| Cutting Height Adjustment Type | Central |
| Grass Collector Volume | 70 L |
| Engine Type | 4-stroke engine |
| Safety Features | Engine stop function |
| Cutting Height Adjustment | Single lever central adjustment |
| Power | 1800 W |
