8
GB
machine. If repairs are necessary, please contact
one of our customer service centers (see address on
warranty certificate).
9. Replace the tiller blades
For safety reasons, we recommend having the tiller
blades replaced by an authorized professional (see
address on warranty certificate).
Important!
Wear working gloves. Use only genuine spare parts
since otherwise the function and safety of the
machine cannot be guaranteed.
10. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
앬 Type of machine
앬 Article number of the machine
앬 Identification number of the machine
앬 Replacement part number of the part required
Helpline numbers:
UK 0151 649 1500
IRE 189 094 6244
11. Technical data
Voltage 230V ~ 50Hz
Power input 750 W
Working width 30 cm
Tiller diameter 22 cm
Idle speed 400 rpm
Number of blades 4 pieces
L
pA
noise level 70 dB(A)
L
WA
peak noise level 93 dB(A)
Vibration at the handlebars a
hv
≤ 2.5 m/s
2
12. Troubleshooting guide
Fault Possible causes Remedy
Motor does not start a) No power at the plug
b) Cable defective
c) Switch/plug block defective
d) Motor terminals or capacitor
disconnected
e) excessive working depth
a) Check the power cable and fuse
b) Check
c) By customer service workshop
d) By customer service workshop
e) Reduce working depth
Motor performance
drops
a) Soil too hard
b) Blades badly worn
a) Correct working depth
b) Replace hoe blades
Important note!
For protection, the motor is equipped with a thermal switch which cuts out when the motor is
overloaded and switches on again automatically after a short cooling period.
To Next Page
Loading...
