GB
- 22 -
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible.
•
We recommend cleaning the equipment im-
mediately each time after use.
8.2 Cleaning the fi lter (Fig. 1/5)
Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plas-
tic parts in the equipment.
8.3 Cleaning the tank (Fig. 1/10)
The tank can be cleaned with a damp cloth and
some soft soap or under running water, depen-
ding on the amount of dirt.
8.4 Cleaning the fi lters
Cleaning the pleated fi lter (Fig. 3/24)
Clean the pleated fi lter (24) regularly by carefully
patting it and cleaning it with a fi ne brush or hand
brush.
Cleaning the foam fi lter (Fig. 3/25)
Clean the foam fi lter (25) with a little soft soap un-
der running water and allow it to air-dry.
Cleaning the coarse fi lter (Fig. 3)
Clean the coarse fi lter (16) with a little soft soap
under running water and allow it to air-dry.
Cleaning the fi lter (Fig. 21a-21b)
The fi lter (2) should be checked at regular inter-
vals and cleaned if necessary.
1. Remove the fi lter cover (2) (Fig. 21a).
2. Take out the fi lter (2) (Fig. 21b).
3. Clean the fi lter by tapping it or blowing it out.
4. Assemble in reverse order
8.5 Maintenance
At regular intervals and before each use, check
that the fi lters in the wet and dry vacuum cleaner
are securely fi tted.
8.6 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
Anl_TE_VC_2340_SAC_SPK9.indb 22Anl_TE_VC_2340_SAC_SPK9.indb 22 07.11.2018 09:48:1907.11.2018 09:48:19
To Next Page
Loading...
