Eizo EX3 - Installing the Software

Installing the software
ColorNavigator Software needs to be installed to enable use of EX3. Refer to the User’s Manual
for the software for further details.
How to attach the EX3
Attention
• Before attaching the EX3, remove the stains or dusts on the surface of the monitor.
1.
Connect the upstream port of monitor and the USB downstream port
of PC with the EIZO USB Cable (MD-C93) supplied with your monitor.
2.
Peel off the protective lm on the EX3 surface.
3.
Remove the cap (counterweight) from the sensor.
Sensor
Counterweight
2