5
Name
Quantity
of modules
Net weight,
kg
HхWхD
(enclosure),
mm
HхWхD
(niche),
mm
Flush-mounted plastic
distribution enclosure 24
24 1,66 350х300х100 320х267х75
Flush-mounted plastic
distribution enclosure 36
36 2,4 482х300х100 450х270х75
Flush-mounted plastic
distribution enclosure 45
45 2,4 505х365х110 470х325х85
3 INSTALLATION AND OPERATION
The distribution enclosures shall be mounted and connected by
qualied electricians. Operating temperature range: from minus 5 °C
to plus 50 °C. The distribution enclosures shall be only used in
non-explosive environments that are free of conductive dust and
chemically active substances.
The distribution enclosures are equipped with a protective operating pan-
el to prevent free access to live parts.
Installation procedure:
1. Open the door of the distribu-
tion enclosure and unscrew the
screws which connect the front
panel and the base of the distri-
bution enclosure.
2. Install the required electrical
equipment onto DIN rail.
3. Connect internal electrical parts,
check the quality of installation.
4. Place the enclosure in its place
of operation and fasten it secure-
ly through the holes provided.
5. Make the necessary cut-outs in the cable entry points with a t-
ter’s knife.
6. Make sure input conductors are de-energized, and connnect
them as intended.
7. Fit the front panel and tighten the screws. See g. 1.
Шины
DIN-рейка
отверстия
для ввода
Bus bars
DIN rail
Perforated
holes
for conductor
entry
To Next Page
Loading...