ELAN | SpeakerCraft | Gefen | Furman | Niles | Panamax | Sunfire | BlueBOLT | Proficient | Xantech
1800 South McDowell Blvd., Petaluma CA 94954 • Toll Free: 800.472.5555 • Fax: 707.283.5901
ELAN CONFIGURATION DETAILS
The following table provides settings used in the ELAN Configurator. Please refer to the Configurator Reference Guide for more details.
o “<Select>” Select the appropriate item from the list (or drop-down) in the Configurator.
o “<User Defined>”, etc. Type in the desired name for the item.
o “<Auto>” This field will automatically populate during configuration
Devices Variable Name Setting Comments
Communication Devices Device Name <User Defined> Only one comm device required for multiple HHR
System# <Auto>
Device Type <Auto>
Option <Select> See Note #1
Interface Devices <Auto Discover> Name <User Defined> Default: ELANHR@xxx.xxx.xxx.xxx See Note #2
System# <Auto>
Driver Version <Auto>
Driver Vendor <Auto>
Device Type <Auto>
Comm Device <Select> See Note #3
Model <Auto> See Note #4
Power Button <Select> See Note #5
Power Press and Hold <Select> See Note #6
Auto-Return to Media <Select> See Note #7
On-Cradle Zone <Select> See Note #8
Timeout <Select> See Note #9
Swipe Support <Select> See Note #10
Notes:
1. Select the UI that will be used on all HHR devices
2. The HHR Remotes are automatically discovered; refer to initial Configuration Notes above
3. If Not already chosen, select the COM device that refers to the HHR Comm devices set above
4. Automatically discovered
5. Select the desired Power Button behavior
6. Select the desired Press and Hold behavior (All Zones off or Sleep Timer)
7. Select the desired return to media control time
8. Select the zone the HR30 will jump to when put on the cradle
9. Select the desired timeout to return the HHR to sleep mode
10. Select whether the swipe function is on or off
To Next Page
Loading...
