© 2021 ELATEC GmbH – TWN4 MultiTech 2 BLE user manual DocRev3 – 07/2021 Page 3 of 11
1 INTRODUCTION
1.1 ABOUT THIS MANUAL
This user manual is intended for the user and enables a safe and appropriate handling of the product. It gives a general overview, as
well as important technical data and safety information about the product. Before using the product, the user should read and
understand the content of this user manual.
For the sake of better understanding and readability, this user manual might contain exemplary pictures, drawings and other
illustrations. Depending on your product configuration, these pictures might differ from the actual design of your product.
1.2 ELATEC SUPPORT
In case of any technical questions, refer to the ELATEC website (www.elatec.com) or contact ELATEC technical support at:
support-rfid@elatec.com
In case of questions regarding your product order or if you wish additional copies of this user manual, contact your Sales representative
or ELATEC customer service at:
info-rfid@elatec.com
1.3 REVISION HISTORY
03
Sections “Disposal” updated under chapter 3 “Safety information”, compliance statement for
United Kingdom added
07/2021
02
Sections “Handling” updated and “Product modifications” added under chapter 3 “Safety
information”, compliance statement for Taiwan updated, compliance statement for Thailand
added
06/2021
01
(replaces Transponder Reader TWN4 MultiTech 2 Quick Start Guide, Rev 1.2, dated
05/2021
2 INTENDED USE
The TWN4 MultiTech 2 BLE reader has integrated RFID (LF & HF) and Bluetooth Low Energy (BLE), which is supported by mobile
phones with Android version 4.3 or greater, iOS 8.0 or greater and PCs with Windows (new Bluetooth hardware integrated). The app
on the reader communicates with the BLE module with easy commands and has direct enhancement to the GATT structure, which
gives you the flexibility to write your custom apps.
The product is for indoor use and may not be used outdoor.
Any use other than the intended use described in this section, as well as any failure to observe the safety information listed in this
document, will be considered misuse and will void the warranty. ELATEC is not responsible for any damage or injuries resulting from
any misuse of the product.
To Next Page
Loading...
