_nsta_Btion instructions
Level machine
Check the dryer is level, and make necessary adjustments.
Adjust all 4 leveling legs to match washer height. Dryer MUST BE LEVEL and rest firmly on all
4 leveling legs.
Level front-to-back
Levd side-to--side
/
/
Fig24 Leveling the mochine
4 eve , g, gs iiiiiiiiiiii
Final installation check [[st
Check that:
o Noplasticorflexiblemetalfoilisusedintheexhaustducting.
° Exhaust is rigid ducting or thick wall flexible metal ducting.
o All joints in the ducting are made with duct tape. It must not be connected with screws or other ,!
fastening devices which extend into the inside of the duct.
o Ductingiscleanandisconnected_othedryer.
o Dryer_slevel.
° Dryer is plugged or directly wired into an approved fitting and is properly grounded. : ]
° Dryer starts, heats, cools and shuts off.
Dryer is pBgged into an approved fitting and is properly grounded.
° A[[ fittings in the gas line are tested for leaks.
o Exhausttemperatureincreases,toconfirmignitionhasoccurred.
- Ifignition does not occur initially, it may be due to air in the gas line or low voB_ge
powersupply.
- -[he gas regulator valve may fail to open if the power supply falls below 105 Volts. i/i
To Next Page
Loading...