T oub eshooting
If there is a problem with your appliance, please check the following points before contacting
your local Fisher & Paykel Appliances Authorized Service Center Dealer or Customer Care Center.
Dryer doesn't start, Dryer is unplugged.
Dryer doesn't heat,
Dryer shakes or
makes excessive
noise,
Greasy spots on
clothes,
Lint on dothes,
Static occurs,
Make sure the dryer plug is pushed
completely into the outRet.
Fuseis blown/circuit breaker is
::tripped.
Fuse is blown/circuit breaker is
tripped, the dryer may tumble
but not heat.
Check the house fuse/circuit breaker
box and replace fuse or reset breaker.
Note: most electric dryers use two
breakers.
Check the house fuse/circuit breaker
box and replace fuse or reset breaker.
Some shaking/noise is normak
Dryer may be sitting unevenly.
Gas service is off. Make sure gas shutoff at dryer and
main shutoff are fully open.
Move the dryer to a flat place on the
floor, or adjust Feet as necessary until
even.
Improper use of fabric softener. Follow directions on fabric softener
package,
Drying dirty items with dean Use your dryer to dry only dean items.
ones. Dirty items can stain dean items and
the dryer.
Clothes were not completely Sometimes stains which cannot be
dean. seen when the clothes are wet 'appear'
after drying. Use proper washing
procedures before drying.
Lint filter is fulk Clean lint screen before each load.
.......................................................................................... 1
Improper sorting. Sort lint producers (like chenille) from
lint collectors (like corduroy).
Static electricity can attract lint. See suggestions in this section under
static.
Overloadin% Separate large loads into smaller ones.
Paper, tissue, etc. left in Empty all pockets before laundering
pockets, clothes.
Overdrying, Try a fabric softener.
Adjust controls for less drying,
No fabric softener was used. Try a fabric softener.
Synthetics, permanent press Try a fabric softener.
and blends can cause static.
To Next Page