Elba EBL-D1552G - Appliance Operation and Safety Lock; Safety Lock Feature; Operating the Blender

4
SAFETY LOCK
This feature ensures that you can only switch on the appliance if you have properly assembled the
glass jar on the motor base. When the glass jar is correctly assembled on the motor base, the jar
seating will push the built-in safety lock on the motor base until it function.
* When moving or handling the blender, the whole unit cannot be tilted in order to prevent
the glass jar from falling down.
OPERATING THE APPLIANCE
1. Unpack the appliance and place it on a flat horizontal counter top. Check all the parts whether all
in good condition.
2. Clean the removable parts before using including the lid, jar cover and glass jar.
3. Make sure that the control switch is not pressed at “LOW”, “HIGH”, “LOW PULSE” or “HIGH
PULSE” position.
4. Peeled or cored the fruits or vegetables and then cut it into small dices. Insert the ingredients
into the glass jar. Usually, certain amount of purified water has to be added to facilitate the
smooth running of the appliance. The proposition of the food and water should be 2:3. The
amount of mixture should not exceed the maximum level as indicated on the jar.
WARNING: Never use boiling water or any other liquids to mix into the ingredients.
NOTE: Never let the appliance to operate empty.
5. Close the glass jar with jar cover. Mount the lid into the jar cover.
6. Insert the glass jar onto the motor base and secure it tightly until it clicks.
7. Power on the appliance and select the desired switch.
8. Press any switch at the control panel according to the food that needed to be blend (refer to the
control panel descriptions) for guideline.
9. For quick or delicate blending tasks, press the “LOW PULSE” or “HIGH PULSE” and hold for a
few seconds and then release, the appliance will reset to off position automatically. Operate
several times until obtaining the result you wanted.
10. If you want to add ingredients while blending, slowly remove the lid from the jar cover and place
the ingredients through the lid.
11. Always switch off the appliance by setting the control switch to “OFF” position before you open
the jar cover.
12. To crush ice, add up to 6 ice cubes. If more ice is needed, remove the lid and add cubes one by
one through the lid opening. When crushing ice or hard food, keep one hand firmly on the glass
jar cover.
13. After the blending process is finished, press the “OFF” switch and power off the appliance.
Unplug the plug from wall outlet after use.