15. Do not use with a voltage converter.
16. When the hairdryer is used in a bathroom, unplug it after use since the proximity of water presents a
hazard even when the hairdryer is switched off.
17. For additional protection, the installation of a residual current device (RCD) having a rated residual
operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom. Ask
your installer for advice.
SERVICING OF DOUBLE - INSULATED APPLIANCES
Your Elchim product is a (class II) double insulated electrical appliance and should not be connected to an
earth connection.
In a double-insulated appliance, two systems of insulation are provided instead of grounding. No grounding
means is provided on a double-insulated appliance, no should a means for grounding be added to the
appliance. Servicing a double-insulated appliance requires extreme care and knowledge of the system, and
should be done only by qualified service personnel.
Replacement parts for a double-insulated appliance must be identical to the parts they replace.
A double-insulated appliance is marked with the symbol (square within a square).
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
This appliance is intended for household use only.
Use on Alternating Current (60 Hertz) only. Standard dryers are designed to operate at 120 AC Volts.
Polarized Plug
This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit
in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
Application Leakage Circuit Interrupter
This appliance is equipped with an Appliance Leakage Circuit Interrupter (ALCI), a safety feature that
renders it inoperable under some abnormal conditions, such as immersion in water. To make sure the ALCI
is functioning properly, perform the following test. The purpose of this test is to allow you to make sure the
water sensing system (ALCI) is working.
1. Plug in the appliance and press test button on plug.
2. The appliance will stop working. There will be an audible click and reset button will pop out. This
indicates the ALCI is functioning properly.
3. To reset ALCI, unit should be unplugged. Then push reset button in and reinsert plug into outlet.
To Next Page
Loading...