600 Randolph Drive, Suite B Appleton, WI 54913
Office: (920) 423-7170 info@velocitywaterworks.com www.velocitywaterworks.com Fax: (844) 348-9001
Window Rinse Controller Quick Start Guide
General Operation
This controller works in cycles. The system will either be on (sending RO water to window rinse
manifolds) for a certain amount of time, and then will be off (in standby) for a certain amount of
time. The amount of time for each cycle can be programed by using the four screws shown
above
Setting Each Cycle Time
The “Rough time setting-PUMP ON” screw and “Fine time setting-PUMP ON” screw shown
above are used to program the amount of time that the windows will be rinsed. The “Rough time
setting-PUMP OFF” screw and “Fine time setting-PUMP OFF” screw represent the amount of
time between window rinses.
To Next Page
Need help?
General
