Need help?Do you have a question about the ELCOS CEM-120 and is the answer not in the manual?
Steps for replacing the control unit, including engine stop and data transfer.
Guide on transferring programming settings to multiple memory units.
Process to reset the control unit to its original factory settings.
Explanation of the standby mode and how to exit it.
How to enter the programming mode to select settings.
Instructions on how to exit the programming mode.
How to access detailed technical programming options.
How to navigate to and display required programming sections.
Procedure to select the desired language for the display.
How to configure the energized mode for stopping systems.
How to set the generator operating frequency.
Procedure for programming the weekly automatic test.
How to select the battery voltage for the system.
How to choose the number of ammeters to display.
How to configure protection devices in manual mode.
How to use Input 41 for programmable protection or device disabling.
How to configure the indication of anomalies or written messages.
How to adjust the running engine threshold based on charging alternator signal.
How to calibrate the tachometer using charging alternator or pickup signals.
How to set the overspeed threshold to stop the engine.
How to program preventive maintenance intervals.
Procedure to delete expired maintenance operations.
How to reset kilowatt-hour, failure counts, and startup counts.
Setting preheating operation time and engine start attempt time.
Configuring pause between start attempts and stopping time.
Setting engine cooling time and delay after call contact closure.
Programming general alarm connection time and weekly self-test duration.
Setting protection for generator voltage staying higher than programmed value.
Generator contactor closing logic based on programmed voltage threshold.
Configuring generator overvoltage protection to stop the engine.
Activating and setting protection for generator frequency below programmed value.
Setting a warning level for generator overload.
Configuring generator overload protection to stop the engine.
Protection logic when the generator fails to supply power.
Setting protection for voltage asymmetry between phases.
Selecting already programmed temperature transmitters.
Selecting already programmed pressure transmitters.
Programming resistive values for temperature and pressure transmitters.
Procedure for switching various instruments on or off.
Selecting the fuel float type for fuel level indication.
Programming resistive values for the fuel float.
Procedure for switching various functions on or off.
Selecting the appropriate current transformer for the system.
Viewing and resetting the log of engine-stopping faults.
Configuration of parameters for Mod Bus and GSM communication.
General| Brand | ELCOS |
|---|---|
| Model | CEM-120 |
| Category | Controller |
| Language | English |
To Next Page
