CP6000MAN v01
13
Figure 5: Battery Installation
CLEANING
• Clean only the exterior of the probe, cables and accessories. Use a soft cotton
cloth moistened with a mild detergent and water solution. To clean the core,
open the jaw and clean the exposed core surfaces with a cotton swap dampened
with isopropyl alcohol. Lubricate the jaws mating surfaces with light oil. Do not
allow any portion of the probe to be submerged at any time.
• Dry the probe and accessory thoroughly before attempting to make any current
measurements.
• Do not subject the probe to solvents or solvent fumes as these can cause
deterioration of the probe body, cables and accessories.
To Next Page
Loading...