CP6000MAN v01
6
WARNING indicates an injury hazard not immediately accessible as you read the
marking.
CAUTION indicates a hazard to property including the product.
• Symbols on the Product. These symbols may appear on the product:
Attention refers to operation Instructions.
This instrument has double insulation.
COMPLIANCE INFORMATION
This section lists the safety, and environmental standards with which the probes
comply.
SAFETY COMPLIANCE
EC Declaration of Conformity – Low Voltage
Compliance was demonstrated to the following specification as listed in the
Official Journal of the European Union:
Low Voltage Directive 73/23/EEC, as amended by 93/68/EEC.
EN 61010-1/A2:1995 – Safety requirements for electrical equipment for
measurement control and laboratory use.
EN 61010-2-032:1995 – Particular requirements for hand-held current clamps for
electrical measurement and test equipment.
ADDITIONAL COMPLIANCES
EN 61010-1/A2:1995 – Safety requirements for electrical equipment for
measurement control and laboratory use.
To Next Page
Loading...