EasyManua.ls Logo

Eldom IC120 - Page 4

Eldom IC120
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operating instruction
R
C o r d l e s s k e t t l e IC120
General description
Technical data
1. On/off switch
2. Lid release handle
3. Opening lid
4. Spout + net filter
5. Base
6. Control lamp
7. Water level indicator
8. Handle
- power: 800W
- mains voltage: 230V ~ 50Hz
- 1.0 litre capacity
- mains protection: 10 A
- protection insulation class I
HOW TO USE THE APPLIANCE
Cordless kettle IC120 is for boiling water.
It is possible to boil 0.5 – 1.0 litre of water in the kettle.
The kettle base (5) must be put on a flat and dry surface.
In the base there is some space for an excess cord. It is important
for the cord to be led from the base (5) through a special groove
so that the appliance could be stable.
Before using the kettle for the first time fill it up (2-3 times) with water, boil the water and then
empty the kettle.
The kettle can be filled with water directly through the spout (4) or after opening the lid (3).
IThe kettle must not be filled up when on the base (5).
The minimum level of boiling water is 0.5 l. The maximum water level (1.0 l) is marked on the
indicator (7).
The kettle starts working after putting the switch (1).
The kettle working is signalled by the control lamp (6).
The kettle switches off automatically after the water has boiled.
You can stop heating water at any time by putting the switch (1).
Cleaning and maintenance
- allow the unit to cool down completely before cleaning,
- do not immerse the kettle in water while washing up,
- the outside of the kettle may be wiped over with a damp cloth
and washing-up liquid,
- water stains inside the kettle can be removed by rubbing with
a cloth moisten with white vinegar; rinse the inside with water afterwards,
- limescale should be removed in the following way:
- fill the kettle with 0.5 litre of water and bring it to boil,
- switch the kettle off and disconnect the kettle from the power supply,
- pour 0.5 litre of white vinegar into the kettle,
- allow to stand overnight,
- discard the solution and rinse the inside with water,
- fill the kettle with 1 litre of water and bring to boil,
- discard the water and rinse the inside with water.
1
4
3
2
8
5
7
6
4

Related product manuals