Elecom WRC-2533GHBK-I

To Next Page

SetupGuide

WRC-2533GHBK-I/WRC-1750GHBK2-I/WRC-F1750ACGH/WRC-1167GHBK2-I

WRC-F1167ACG/WRC-1167GEBK-I/WRC-F1167ACF/WRC-733GHBK-I

WRC-733GEBK-I/WRC-300GHBK2-I

Nameandfunctionofeachpart

WPSlamp

(red)

Blinking:TheWPSsettingbuttonhasbeenpressed,andtheWPSfunctionisrunning.

Thislampblinksonceevery0.5secondforapproximately2minutes.

Thelampindicatestheconnectionstatusofthe2.4GHzband(11n/g/b)and

the5GHzband(11ac/n/a).

Lit : Thecorrespondingbandisbeingconnectedtoawirelessclient(wirelessadapter).

Blinking : Thecorrespondingbandhasbeenconnectedtoawirelessclienttousefor

 lessthan10seconds.

Oﬀ : Therearenowirelessclientusingthecorrespondingband.

Oﬀ:TheWPSfunctionisnotrunning

POWERlamp

(blue)

＊1

Lit : Theproductison.

Oﬀ : Theproductisoﬀ.

2.4GWLANlamp

(blue)

＊1

5GWLANlamp

(blue)＊1 ＊2

WPSsetting

button

Resetbutton

RT/APmode

changeoverswitch

LANport/

LANlamp1to4

(blue)

＊1

INTERNETport/

INTERNETlamp

(blue)

＊1

DCIN

(powersupplyjack)

Stand

■Thefactorydefaultvaluesofsettingutility

■FactorydefaultvaluesrelatedtowiredLAN

■Factorydefaultvalues(initialvalue)relatedtowirelessLAN

•UsethesidewiththeLEDlampsasthefront.

•Refertotheillustrationandsettheproduct

intotheincludedstandsothatthebackof

theproductﬁtssnuglyinthegroovesonthestand.

•UsethesidewiththeLEDlampsasthetop.

•Placetheproductontheincludedstandsothat

theproductisontopofthecenter,backpartof

thestand,andthenensurethattheproductissteady.

◆Horizontalorientation◆Verticalorientation

Installationmethodandprecautions

Primaryspeciﬁcationandfactorydefaultvalues(initialvalue)

Thestandisnotﬁxedtotheproduct.Connectthecablestotheproduct,andthen

settheproductintothestand.

APmode

RTmode

Thisproductcanbeinstalledverticallyorhorizontally.Witheitherorientation,besure

tostabilizetheproductbysettingitintotheincludedstand.Also,witheitherorienta-

tion, take measures to prevent the product from falling over and the cables from

being pulled out. The product falling over or the cables being pulled out from the

connectorswhiletheproductisinoperationmayleadtomalfunctionsordataloss.

Leftside Back

Usethisbuttonwhenyouareconnectingtheproducttoawirelessslave

device(suchasawirelessadapter)thatisequippedwithaWPSfunction.

Tousethisfunction,pressthisbuttonfor2secondsormore.

Whenyoupressthisbuttonformorethan10seconds,thePOWERlampblinks

andtheproduct'ssettingsareinitialized(returnedtothefactorydefaultvalues).

DonotturnoﬀtheproductuntilthePOWERlampstopsblinking.

UsethisswitchtoselectwhethertousethisproductineitherRT

(router)modeorAP(accesspoint)mode.Initialsettingis“RTmode”.

UsetheseportstoconnectthisproducttoPCsorothernetworkdevicesovera

wiredLAN.ThereisanLEDlampnexttoeachport.

Lit : ThelinktothePCornetworkdeviceconnectedoverawiredLANhasbeen

established.Blinking : Dataisbeingtransferred.Oﬀ : Thecableisdisconnected.

ConnectthecablefromtheWAN(Internet)deviceofthemodem(ONU,CTU,

andothertypes).ThereisanLEDlampnexttotheport.

Lit : ThelinktotheWANdevicehasbeenestablished.Blinking : Dataisbeing

transferred.Oﬀ : Thecableisdisconnected.

ConnecttheACadapterincludedwiththisproducttothisjack.Donotconnect

anyACadaptersotherthantheoneincludedwiththisproduct.

Youcanusethestandincludedwiththisproducttoorientitverticallyorhorizontally.

Fordetailsonhowtousethestand,see"Installationmethodandprecautions"below.

Usernameand

passwordforlogin

Routerbody

IPaddress(LANside)

DHCPserver

function

Username : admin

＊RouterandAPmode

DHCPserverfunction : Valid

AssignmentIPaddress :

Password : admin

ChildnetSSID(2.4Gonly)

Encryptionsystem : WPA2-PSK(AES)

Encryptionkey

Setupinformationsheet

Encryptionkey

Encryptionkeylabel

(A13-characterrandom

combinationofthe

numbers0to9and

lettersAtoHwillgoin

theplaceofX.)

Encryptionkeyiswrittenontheencryptionkeylabelon

thebottomsurfaceofproductandtheincludedsetup

informationsheet.

Encryptionkey(password) : Writtenontheencryptionkeylabelontheproductand

theincludedsetupinformationsheet(seebelow)

＊SSIDiswrittenontheincludedsetupinformationsheetXsarerandomhalf-width

charactersselectedfromthenumbers0to9andlettersatof.

Westronglyrecommend

thatyouchange

thepassword(admin).

Back

Thismanualprovidesasummaryofandthespeciﬁcationsforthisproductaswellasexplainsthisproduct'susage

precautions.

ItalsocontainsanFAQthatexplainsactionsyoucantakeifyouhaveproblemssuchastheproductmalfunctioning.

Howtoinstallthisproduct(wirelessrouter)

Connectthedevices.

Refertothediagramand

wirethedevices.

Terminaldevice

(cableTVmodem,ONU,CTU,ADSL)

LANcable

INTERNETport(blue)

＊

Verticalorientation

POWER : Lit

INTERNET:

Blinkingorsolid

❶

ToanACoutlet

ACadapter

ACoutlet

❶Connectthepowercableoftheterminaldevice.

Ifapowerswitchispresent,slide

theswitchtotheonposition.

❷ConnecttheincludedACadapter

tothisproduct.

Turnontheterminaldeviceandthisproduct.

Checkthelitstatusofthelamps.

•Checkthatthelampsonthemodemorsimilardeviceand

thisproductarelitcorrectly.

Beforewiring,checkthe

modeswitchonthe

backofproductison

the“RTside”.

＊Initialsettingis“RT

mode”.

Includedstand

PleasereferenceP1oftheattachment“Productinformation”forthe

detailsofthemethodtoattachthestand.

Connectallthewiresbeforeattachingthestandtothisproduct.

APmode

RTmode

*Thereisno5GWLANlampontheWRC-300GHBK2-I.

＊1ThelampofWRC-2533GHBK-Iiswhite(exceptWPSlamp).

＊2Thereisno5GWLANlampontheWRC-300GHBK2-I.

Need help?

Do you have a question about the Elecom WRC-2533GHBK-I and is the answer not in the manual?

Summary

Name and Function of Each Part

Device Components Overview

Describes physical ports, buttons, and indicator lamps on the device.

WPS and Status Indicator Lamps

Explains the function and status of WPS, Power, and WLAN indicator lamps.

Control Buttons and Switches

Details the function of the WPS button, Reset button, and RT/AP mode switch.

Connectivity Ports

Outlines the purpose and indicators for LAN, INTERNET ports, and the power input jack.

Included Stand

Information on the included stand for vertical or horizontal device placement.

Primary Specification and Factory Defaults

Login Credentials and Default Settings

Provides default login credentials (admin/admin) and advises changing them.

Wireless LAN Default Values

Lists default SSIDs (2.4GHz, 5GHz, Child Net) and encryption settings.

Wired LAN Default Values

Details default IP address, DHCP server settings, and encryption key location.

Installation Method and Precautions

Device Placement Options

Explains how to install the product vertically or horizontally using the included stand.

Installation Precautions

Advises on preventing the product from falling or cables from being pulled out during operation.

How to Install This Product (Wireless Router)

Connecting Devices and Powering On

Guides on connecting the modem, terminal device, and powering them on.

Verifying Indicator Lamp Status

Instructs to check the status of indicator lamps on the modem and the product after connection.

Configuring Settings via Smartphone or Tablet

Step 1: Connect to Product (Wireless Master Device)

Guides on connecting an Android or iOS device to the product using a QR link app.

Step 2: Connect to the Internet

Details connecting to the internet via web browser, including DHCP, PPPoE, and static IP setups.