Need help?Do you have a question about the Elecro Engineering In-Line + Swimming Pool Heater and is the answer not in the manual?
General| Brand | Elecro Engineering |
|---|---|
| Model | In-Line + Swimming Pool Heater |
| Category | Swimming Pool Heater |
| Language | English |
Heater must be fixed horizontally and upright to a firm base or wall.
Minimum 1½" (32mm) pipe bore required. Incorporate a safety loop on the return pipe.
Installation must be by a qualified electrician and the power supply must have an RCD.
Operate between 1,000 and 17,000 litres per hour. Higher flow requires a bypass.
Lists acceptable ranges for pH, alkalinity, chlorine, bromine, TDS, and calcium hardness.
Explains how to use the power, temperature adjustment, and priority heating buttons.
Illustrates wiring for pump control, bypassing time clock, and connecting to contactor coil.
Troubleshooting steps for when the heater fails to switch to the ON mode.
To Next Page
