How to fix Electra Dishwasher when the programme does not start?
Several issues can prevent your Electra Dishwasher programme from starting. Ensure the dishwasher is plugged in and switched on. Check your indoor fuses and make sure the water inlet tap is open. Also, verify that the dishwasher door is fully closed and that the water inlet hose and machine filters are not clogged.
Why does my Electra C4510IE Dishwasher keep stopping during washing?
If your Electra Dishwasher stops mid-cycle, the cause might be a power failure. Check your mains power. Alternatively, there may be a water inlet failure, so check the water tap.
What to do if water remains inside Electra Dishwasher?
If water remains inside your Electra Dishwasher, the drain hose might be clogged or twisted; inspect and clean or untwist it. Clogged filters could also be the problem, so clean them. Finally, ensure the programme has fully completed; if not, wait until it finishes.
Why does detergent remain in the Electra C4510IE compartment?
If detergent remains in the detergent compartment of your Electra Dishwasher, it may be because the detergent was added when the compartment was wet. Before adding detergent, ensure the compartment is dry.
Why does my Electra C4510IE Dishwasher leave whitish stains on dishes?
If you find whitish stains on your dishes after washing in your Electra Dishwasher, it could be due to not using enough detergent. Refer to the programme table for the correct amount. Also, the rinse aid dosage and/or water softener setting might be too low; increase these levels. If the water hardness level is high, increase the water softener level and add salt. Lastly, ensure the salt compartment cap is properly closed.
How to improve drying in Electra C4510IE Dishwasher?
If your dishes are not drying in the Electra Dishwasher, first ensure that you have selected a programme with a drying option. If you have, then the rinse aid dosage might be set too low; try increasing the rinse aid dosage setting.
Why does Electra C4510IE leave food waste on dishes?
If partial food wastes remain on the dishes after a wash in your Electra Dishwasher, it could be due to several reasons. Make sure you are not overloading the baskets. If dishes are leaning against each other, rearrange them as instructed in the loading section of your dishwasher guide. Ensure you are using enough detergent as per the programme table. Select the most appropriate wash programme using the programme table. Clean the holes in the spray arms if they are clogged with food waste, and check that the drain hose and filters are correctly fitted.
Why does Electra C4510IE Dishwasher cause rust stains on the dishes?
Rust stains on dishes from your Electra Dishwasher can occur if the stainless-steel quality of the dishes is insufficient; use only dishwasher-proof sets. A high level of salt in the wash water can also cause this; adjust the water hardness level using the water hardness table. Ensure the salt compartment cap is closed properly. Use a funnel when filling salt to avoid spillage. A poor mains grounding may also be the cause.
What causes shaking noises in Electra C4510IE Dishwasher during wash?
If you hear shaking and hitting noises during a wash operation with your Electra Dishwasher, the spray arm is likely hitting dishes in the lower basket. To resolve this, move or remove any items that are blocking the spray arm.
Essential safety guidelines for installation, operation, and general use of the appliance.
Guidance on positioning, connections, and preparing the dishwasher for initial operation.
Instructions for loading dishes, using the control panel, and selecting programmes.
Procedures for cleaning essential components like filters, spray arms, and the drain pump.
A guide to identifying and resolving common operational issues and faults.
General| Languages | English |
|---|---|
| Door color | White |
| Water fill | Cold |
| Cord length | 1.65 m |
| Control type | Buttons |
| Display type | LED |
| Product size | Slimline (45 cm) |
| Tub material | Stainless steel |
| Certification | CE, REACH, RoHS |
| Product height | Standard (80 - 85 cm) |
| Built-in display | No |
| Inlet hose length | 1.47 m |
| Number of baskets | 2 basket(s) |
| Upper basket rack | Fixed |
| Control panel type | Symbolic |
| Custom panel-ready | Yes |
| Outlet hose length | 2 m |
| Appliance placement | Fully built-in |
| Cutlery compartment type | Basket |
| Baskets adjustable placement | Upper |
| Upper basket adjustable height levels | 2 |
| Cycle time | 222 min |
| Noise level | 54 dB |
| Drying system | Residual heat |
| Delay start (max) | 9 h |
| Dishwashing programs | Economy, Express 50min, Intensive 65 ºC |
| Number of place settings | 10 place settings |
| Number of washing programs | 3 |
| Net weight | 32000 g |
| Drying class | A |
| Gross weight | 34000 g |
| Country of origin | Turkey |
| Dimensions (WxDxH) | 448 x 550 x 820 mm |
| Annual water consumption | 3080 L |
| Annual energy consumption | 211 kWh |
| Power plug type | Type G |
| Energy efficiency scale | A to G |
| Power consumption (off) | 0.5 W |
| Power consumption (left-on) | 1 W |
| Water consumption per cycle | 11 L |
| Energy consumption per cycle | 0.755 kWh |
| Package depth | 661 mm |
| Package width | 494 mm |
| Package height | 861 mm |
| Package weight | Weight of the packaged product in gram. |
| Quantity per pack | 1 pc(s) |
| UK Trade Tariff code | 84221100 |
| Minimum order quantity | 208 pc(s) |
| Shipping (inner) case height | 851 mm |
Weight and Dimensions| Depth | 550 mm |
|---|---|
| Width | 448 mm |
| Height | 820 mm |
To Next Page