8
3. Hand tighten the pedals onto the crank arms. Make sure you
tighten the nut and not the pedal itself.
4. Fully tighten the pedals. When at the correct tightness, the
tool leaves a noticeable impression in the palm of your hand.
5. Wipe off any excess grease.
Install the pedals (continued).
TIP: Both pedals tighten towards the front of the bike.
WARNING: The chainring has sharp points. Be careful when
working around the chainring. Failure to do so may result in cuts
or pinched skin.
Tools needed
for this step:
PEDALS
4
Drive side
Non-drive side
CONTINUED
To Next Page
Loading...
