Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
and 25 Watt rating.
To Replace the Light Bulbs
① Remove the ve (5) screws
from the access panel, located on
the back of the unit, and remove
access panel (Figure 3).
Maintenance
Clear Door Panel Cleaning
The clear door is cleaned in
the factory during the assembly
operation. During shipment,
installation, handling, etc., the
clear door may collect dust
particles. These can be removed
by dusting lightly with a clean, dry
cloth.
To remove ngerprints or other
marks, the clear doors can be
cleaned with a damp cloth. The
clear door should be completely
dried with a lint free cloth to
prevent water spots.
To prevent scratching, do not use
abrasive cleaners or spray liquids
on the clear door surface.
Compact Stove Surface
Cleaning
Use warm water only to clean
painted surfaces of the Compact
Stove. Do not use abrasive
cleaners.
Servicing
Except for light bulb replacement
and cleaning described above, an
authorized service representative
should perform any other
servicing.
Figure 3
② Locate and examine the bulbs
to determine if replacement is
required.
③ Unscrew the bulb(s) counter
clockwise.
④ Insert and install new bulbs.
⑤ Secure access panel to unit.
Bulbs (2)
Screws
(5)
Access Panel
To Next Page
Loading...
