EasyManua.ls Logo

Electralog Electric Fireplace - Page 7

Electralog Electric Fireplace
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
!
NOTE: A15Amp,120Voltalternatingcurrent(VAC)circuitis
required.Adedicatedcircuitispreferredbutnotessentialinall
cases.Adedicatedcircuitwillberequiredif,afterinstallation,the
circuitbreakertripsorfuseblowsonaregularbasiswhenthe
heaterisoperating.Additionalappliancesonthesamecircuitmay
exceedthecurrentratingofthecircuitbreaker.
WARNING: Ensure the power cord is not installed so that it is
pinched or against a sharp edge and ensure that the power cord is
storedorsecuredtoavoidtrippingorsnaggingtoreducetheriskof
re,electricshockorinjurytopersons.
Construction and electrical outlet wiring must comply with local
buildingcodesandotherapplicableregulationstoreducetheriskof
re,electricshockandinjurytopersons.
Donotattempttowireyourownnewoutletsorcircuits.Toreduce
theriskofre,electricshockorinjurytopersons,alwaysusea
licensedelectrician.
(No assembly required for the at wall mantel)
Corner Mantel
Assembly
Assemblethe 1.
top of the mantel
to the rear
support using
the supplied
hardware.
Usingthe 2.
supplied
hardware
assemblethe
top and rear
support
assemblytothe
mainreplace
body(Figure2).
4
Figure 2
Rear Support
MainBody
Mantel Top
Hardware
www.sylvane.com 1-800-934-9194