Electralog Electric Fireplace - Fireplace Installation and Operation; Operation

Fireplace Installation
1. Makesuretheunit’sMainON/OFFswitchisswitchedOFF(refer
 tooperatinginstructionsection).
2. Plugtheunitintoa15Amp,120VACoutlet.Ifthecorddoesnot
 reach,youmayuseaNo.14AWGminimumsizeextensioncord
 ratedforaminimumof1875Watts.
Operation(Figure3)
Toaccessthecontrols,swingdownthefrontcoverpanellocatedon
thelowerfrontofthereplace(refertodiagrambelow).
5
A. Main Three Position ON/OFF Switch
TheswitchhastwoONpositionsmarkedwith
and “Manual”.The
“Manual“positionisformanualoperation.Inthispositionthebuilt-in
remotecontrolisby-passed.
The
positionisforoperatingtheunitwiththeprovidedremotecontrol.
When in
position,theunitisoperatedwiththeONandOFFbuttons
oftheremotecontrol.
Whentheswitchisinthecenterpositiontheunitisoff.
B. Heater ON/OFF Switch
TheHeaterON/OFFSwitchsuppliespowertotheheaterfanandthe
heaterelement.WhentheswitchisintheONpositiontheheater
operatesifthethermostatcallsforheat.
C. Heater Thermostat Control
Toadjustthetemperaturetoyourindividualrequirements,turnthe
thermostatcontrolclockwiseallthewaytoturnontheheater.When
theroomreachesthedesiredtemperature,turnthethermostatknob
Figure 3
AC B
www.sylvane.com 1-800-934-9194