DC-One
Owner‘s Manual 35
System
This window displays the firmware version currently running on the
DC-One.
RS-232 Port
An RS-232 (DB-9 or ‘D-Sub’) connection is provided on the back
panel to link to another DC-One to enable Master/Slave operation.
Use the <SELECT> key to navigate to the MODE parameter and
use the up/down VALUE arrows to choose between RS-232 and
Contacts.
Contacts allow control messages to select individual presets (per pin 1-9) using a remote device. The
additional CONTACTS parameter is used as a display only and corresponds to the binary values of
individual pins, ie - on/off.
For more on this see Relay Contact Closure on page 17.
To Next Page
Loading...
