Electro-Voice PSX1000 User Manual

Essential guidelines to prevent fire, shock, and ensure safe operation of the appliance.

Instructions for qualified personnel regarding safe servicing procedures.

Guidance on setting up speakers and initial device positioning for optimal sound.

Steps for connecting equipment, activating power, and performing basic testing.

Fine-tuning sound with EQ, effects, and level controls.

Introduction to the PSX mixer, its design, capabilities, and benefits.

Procedures for unpacking, checking contents, and warranty registration.

Guidelines for device placement, airflow, and initial mains connection.

Connecting low-impedance microphones, phantom power, and gain settings.

Connecting line-level sources and using the insert jack for processing.

Adjusting input sensitivity, low-cut filtering, and voice shaping.

Using the LO, HI, and MID EQ controls for sound shaping.

Fine-tuning sound with the parametric EQ and MID frequency controls.

Routing signals to internal or external effects units.

Using Aux 3 for monitors/FX, stereo panning, and pre-fader listening.

Monitoring signal levels and adjusting channel volume.

Connecting MIC/LINE stereo sources, Gain, and Line Trim adjustments.

Using the BAL control for stereo image positioning.

Shaping sound with EQ and routing to effects via Aux/FX.

Using BAL, PFL, Signal/Peak indicators, and Volume fader.

Description of the 18-bit stereo effects units and program selection.

Using display, UP/DOWN buttons, FX to AUX3, and SEND controls.

Turning FX units on/off and monitoring input signal levels.

Adjusting the level of effects in the main mix.

Outputting monitor signals and using the feedback filter.

Setting AUX3 signal path and controlling monitor volume.

Using the mono output and connecting headphones.

Adjusting headphone volume and engaging standby mode.

Routing stereo signals and sending to recording devices.

Connecting and mixing 2-track sources into the main mix.

Connecting external gear to main outputs and inserts.

Connecting EQ, power amps, footswitches, and lamps.

Understanding POWER ON, LIMIT, and PROTECT indicators.

Using phantom power and the 7-band graphic EQ.

Monitoring output levels and using master PFL.

Adjusting main outputs and details on the power amplifier.

Connecting speakers via SPEAKON and the main power switch.

Guidance on cabling, speaker cables, and LF-cables.

Explanation of balanced vs. unbalanced signal paths.

Positioning the PSX, amplifiers, and speakers for optimal performance.

Connecting microphones, keyboards, and other sound sources.

Adjusting input levels and EQ for mono and stereo channels.

Performing sound checks for all input types.

Setting master faders, channel levels, and FX mix.

Adjusting monitor levels, using feedback filter, and adding effects.

Connecting external power amplifiers and mixing consoles.

Illustrating various connection possibilities of the master patchbay.

Using internal amp for monitoring or side-fills.

Configuring the PSX for monaural sound reinforcement with monitoring.

Connecting multiple speakers in a passive setup.

Using active crossovers with internal amp for Hi/Mid cabinets.

Technical specifications for output power and distortion levels.

Specifications for input sensitivity, level, and impedance.

Specifications for noise, phantom power, weight, and dimensions.

Details of the Electro-Voice limited warranty and exclusions.

Procedures for requesting warranty service and support contacts.