Electrolux Professional WE170P - 1.3 Electrical Connection; 1.4 Water connection

1.3 Electrical Connection
• The appliance must be correctly earthed. The
manufacturer is not responsible for the consequences
of an inadequate earthing system.
• Always use a correctly installed shockproof socket.
• Make sure that the parameters on the rating plate are
compatible with the electrical ratings of the mains power
supply.
• Do not use multi-plug adapters and extension cables.
• Make sure not to cause damage to the mains plug and
to the mains cable.
• If the supply cord is damaged, it must be replaced by
the manufacturer, its Authorised Service Centre or
similarly qualied persons in order to avoid a hazard.
• Connect the mains plug to the mains socket only at the
end of the installation. Make sure that there is access to
the mains plug after the installation.
• Do not touch the mains cable or the mains plug with
wet hands.
• Do not pull the mains cable to disconnect the appliance.
Always pull the mains plug.
• Only for UK and Ireland: The appliance has a 13 A
mains plug. If it is necessary to change the fuse in the
mains plug, use a 13 A ASTA (BS 1362) fuse.
1.4 Water connection
• Do not cause damage to the water hoses.
• The appliance is to be connected to the water mains
using the new supplied hose-sets. Old hose sets must
not be reused.
• Before connection to new pipes, pipes not used for a
long time, where repair work has been carried out or
new devices tted (water meters, etc.), let the water ow
until it is clean and clear.
• The operating water pressure (minimum and maximum)
must be between 0.5 bar (0.05 MPa) and 10 bar (1.0
MPa).
ENGLISH 39