Step 1 Turn off the oven and wait until it is
cold.
Step 2 Pull the front of the shelf support
away from the side wall.
Step 3 Pull the rear end of the shelf support
away from the side wall and remove
it.
Step 4 Install the shelf supports in the oppo‐
site sequence.
The retaining pins on the telescopic
runners must point to the front.
11.4 How to use: Catalytic cleaning
The cavity is coated with catalytic enamel. It
absorbs fat during catalysis.
Spots or discolouration of the catalytic
coating have no effect on the cleaning.
Before the catalytic cleaning
Turn off the oven and wait until it is
cold.
Remove all accessories and remova‐
ble shelf supports.
Clean the oven floor and the inner
door glass with warm water, soft
cloth and mild detergent.
Clean the oven with catalytic cleaning
Step 1 Step 2 Step 3
Set the function and the oven tem‐
perature: 250 °C
Duration: 1 h
After cleaning, turn the knob for the
oven functions to the off position.
When the oven is cold, clean the
cavity with a wet soft cloth.
11.5 How to remove and install:
Door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
ENGLISH 33
To Next Page
Loading...
