6 7
19 20
21 22
23 24
25 26
Getting the best results
Use the nozzles as follows:
Carpets: Use the combination oor nozzle with the lever in position (19).
Hard oors: Use the combination oor nozzle with the lever in position (20).
Wooden oors: Use the parquet nozzle* (21).
Upholstered furniture and fabrics: Use the upholstery nozzle* (22) for sofas, curtains, lightweight fabrics etc. Reduce
suction power if necessary.
Frames, bookshelves, etc.: Use the feather duster* (23).
Crevices, corners, etc.: Use the crevice nozzle* (24).
Using the turbo nozzle*
25 Ideal for carpets and wall-to-wall carpeting to remove stubborn u and pet hairs.
26 Adjust the suction power by opening or closing the air vent.
Note: Do not use the turbo nozzle on skin rugs or carpet fringes. To avoid damaging the carpet, do not keep the nozzle
stationary whilst the brush is rotating. Do not pass the nozzle across electric cables, and be sure to switch off the
vacuum cleaner immediately after use.
* Certain models only.
* Certain models only
Emptying and cleaning the dust container
CycloneXL’s dust container must be emptied when it is full.
27 Pull the release button at the rear of the vacuum cleaner.
28 Lift the dust container out.
29 Open the lid of the dust container by pressing the release button on the right.
30 Empty it over a wastepaper basket. Put the dust container back (31) and press the rear part of the container
until it clicks into place.
32 Every now and then the dust container should be cleaned. Remove lids at both ends and rinse the container
in water or machinewash it. Remove particles that may be stuck in the cone.
32
31
28
27
29
30
To Next Page
Loading...
