8 9
33
34
36
37
38
35
* Certain models only.
Cleaning the motor lter and the dust container lter
CycloneXL has a motor lter and a dust container lter that should be cleaned now and then.
33 Open the front lid and lift out the dust container.
34 Dust container lter: Remove the lter holder from the dust container and carefully pull the dirty dust contai-
ner lter out of the holder.
35 Motor lter: Pull the lter upwards until coming away from the groove.
36 Rinse the lters in lukewarm water and let them dry. Reattach the clean lters. Replace the dust container
and then close the lid.
Cleaning/replacing the exhaust lter*
There are three types of exhaust lter:
• Micro lter* (Ref. No. EF 17)
• Hepa H12* non washable (Ref. No. EF H12)
• Hepa H12* washable (can be bought as an option, Ref. No. EF H12W)
The filters must always be replaced with new ones and cannot be washed (except the Hepa H12* washable).
37 Open the back lid and lift out the filter.
38 Insert a new lter and close the lid.
42
39
40
41
43
44
45
* Certain models only.
Cleaning the hose and nozzle
The vacuum cleaner stops automatically if the nozzle, tube, hose or lters become blocked and when the dust
container is full. In such cases, disconnect from mains and allow to cool for 20-30 minutes. Clear blockage and/or
replace lters, empty the dust container and restart.
Tubes and hoses
39 Use a cleaning strip or similar to clear the tubes and hose.
40 Hose handle could be dismantled from hose if cleaning is needed.
41 It may also be possible to remove the obstruction in the hose by squeezing it. However, be careful in case the
obstruction is caused by glass or needles caught inside the hose.
Note: The warranty does not cover any damage to the hose caused by cleaning it.
Cleaning the oor nozzle
42 Be sure to frequently clean the combination oor nozzle.
43* Press each wheel-hub and draw away the wheels. Remove dust-balls, hair or other objects that may be
entangled.
44* Larger objects can be accessed by removing the connection tube from the nozzle.
Cleaning the turbo nozzle*
45 Disconnect the nozzle from the vacuum cleaner tube and remove entangled threads, etc. by snipping them
away with scissors. Use the hose handle to clean the nozzle.
To Next Page
Loading...
