5
8. Plug in the wine cellar and turn it on with the S1
switch (see FIG. 5).
Temperature setting
(see FIG. 6)
The wine cellar is equipped with an electronic control.
This allows you to program the temperature inside the
wine cellar. Your wine will be stored between 50 F
(10°C) and 59 F (15°C) according to expert advice.
The temperature pre-set in the factory is shown on the
display.
The temperature, [pre-set at 54 F (12°C)], can be
changed on demand between 46 F (8°) and 64 F
(18°) depending on the wine stored.
1. Press button [1] (see FIG. 6). While pressing
button [1] go to next point (2)
2. Use buttons [2] and [3] (see FIG 6) to lower or
increase the temperature.
3. Please allow 6 seconds for the control system to
record the new pre-set value.
S1
FIG 5
FIG 6
1
2
3
FIG 4a
6. Fit the door handle to the door as shown in
FIG 4a,4b,4c
FIG 4b
FIG 4c
7. Check that the charcoal filter is in place at the top
left corner inside the wine cellar.
You should replace the inside ventilation charcoal filter
every second year. The filter is fitted in the upper left
corner inside the wine cellar.
To Next Page
Loading...
Need help?
General
