11
ENGLISH
Operating sequence
Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 20 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door by pressing the relevant button.
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does
not get caught between the door and filter.
5. Select the drying programme or time: the mains-
ON light comes on.
6. If required, press the low temperature button
and/or the buzzer OFF button .
7. Press the Start button : light comes on and
drying starts.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 9 minute
cooling phase (the light is on and the buzzer
sounds).
You may remove the laundry after this phase.
8. If the laundry is not removed at the end of the
cycle, the dryer performs an anti-creasing phase
(duration: 30 minutes maximum).
The buzzer sounds every 10 seconds (if the
button has not been pressed).
Lights and flash alternately.
If you do not remove the laundry, the dryer will stop
automatically at the end of the anti-creasing phase.
Lights and flash alternately and the mains-
ON light stays on.
Turn the programme selector dial to “0”, all the
lights go out.
9. Remove the laundry.
After each use
• Switch the appliance off by turning the programme
selector dial to “0”. The mains-ON light goes out.
• Clean the filter and empty the water reservoir (see
page 13).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position (cooling) and
wait until the end of this phase before removing the
laundry. This will avoid a build-up of heat inside the
appliance.
Modifying the programme
To change a programme which is running, first cancel
it by turning the programme selector dial to “0”. Select
the new programme and press the Start button .
To Next Page
Loading...
