EasyManua.ls Logo

Electrolux EDE 403 M - Maintenance; Servicing; Troubleshooting Dryer Not Starting; Troubleshooting Poor Drying

Electrolux EDE 403 M
9 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
ENGLISH
MAINTENANCE
Important
You must disconnect the appliance from the electrici-
ty supply, before you can carry out any cleaning or
maintenance work.
External cleaning
Use only soap and water and then dry thoroughly.
From time to time, apply a little wax furniture cream
with a soft cloth.
Important: do not use methylated spirit, diluents or
similar products.
Cleaning the door
Clean periodically the
interior part of the door to
remove any fluff.
Accurate cleaning en-
sures correct drying.
Cleaning the filter
Your dryer will only func-
tion well if the filter is
clean.
The filter collects all the
«fluff» which accumu-
lates during drying and it
must therefore be
cleaned at the end of
each programme with a
damp cloth.
The filter cannot be removed.
It is perfectly normal for fluff to accumulate in the filter
during drying. In fact, even fabrics dried in the open
air lose their fibres, but we do not notice it.
P0328
SERVICING
Before contacting your local Electrolux
Service Centre, please make the following
checks:
The dryer does not start up
The door is open
The plug is not fitted into the wall socket
There is no electricity supply from the wall socket
The time selector dial is not set correctly
The dryer does not dry properly
The filter is clogged
Insufficient drying time
Excessive laundry load
The dryer is not correctly installed
If, after the above checks, there is still a fault, call your
local Electrolux Service Centre.
Please make sure you give the model and serial num-
ber of the appliance.
This information can be
found on the rating plate
(see picture) or on the
guarantee card.
P0307
Mod. ...
Prod. No. ........
Ser. No. ............

Related product manuals