Electrolux EDE1071PDW - Cleaning the Control Panel and Housing; Troubleshooting

12.3 Cleaning the control panel
and housing
Use a standard neutral soap detergent to
clean the control panel and housing.
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.
CAUTION!
Do not use furniture cleaning
agents or cleaning agents
which can cause corrosion
to clean the appliance.
13. TROUBLESHOOTING
Problem Possible solution
You cannot activate the appliance. Make sure that the mains plug is connec‐
ted to the mains socket.
Check fuse in fuse box (domestic installa‐
tion).
The programme does not start. Press Start/Pause.
Make sure that the appliance door is
closed.
The appliance door does not close. Make sure that the installation of the filter
is correct.
Make sure that the laundry does not
catch between the appliance door and
the rubber seal.
The display shows a long programme du‐
ration.
1)
Make sure that the weight of the laundry
is applicable to the duration of the pro‐
gramme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry
in the washing machine again.
Make sure that the room temperature is
not too warm.
The display shows a short programme
duration.
Set the Time Drying or the Extra Dry pro‐
gramme.
The display shows Err
2)
.
If you want to set a new programme, de‐
activate and activate the appliance.
Make sure that the options are applicable
to the programme.
The display shows (e.g. E51)
2)
.
Deactivate and activate the appliance.
Start a new programme. If the problem
occurs again, contact the Service.
1)
After maximum 5 hours, the programme ends automatically
2)
only dryers with the display.
ENGLISH 13