Problem and alarm code Possible cause and solution
Malfunction of the wash
pump or the drain pump.
The display shows i51 -
i59 or i5A - i5F.
• Switch the appliance off and on.
The temperature of the wa‐
ter inside the appliance is
too high or malfunction of
the temperature sensor oc‐
curred.
The display shows i61 or
i69.
• Make sure that the temperature of the inlet water
does not exceed 60°C.
• Switch the appliance off and on.
Technical malfunction of
the appliance.
The display shows iC0 or
iC3.
• Switch the appliance off and on.
The level of water inside
the appliance is too high.
The display shows iF1.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation in‐
structions.
Network unit error.
The display shows iC4
Network Interface Error
or iC5 Network Interface
Error.
• Contact an Authorised Service Centre.
The appliance stops and
starts more times during
operation.
• It is normal. It provides optimal cleaning results and
energy savings.
The programme lasts too
long.
• If the delay start option is set, cancel the delay set‐
ting or wait for the end of the countdown.
• Activating options often increases the programme
duration.
The displayed programme
duration is different than
the duration in the con‐
sumption values table.
• The pressure and the temperature of the water, the
variations of the mains supply, the options, the quan‐
tity of dishes and the degree of soil can change the
programme duration.
The remaining time in the
display increases and
skips nearly to the end of
the programme duration.
• This is not a defect. The appliance is working cor‐
rectly.
Small leak from the appli‐
ance door.
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
ENGLISH 29
To Next Page
Loading...
