Electrolux EEG68520W - Page 16

to remotely control and monitor your
dishwasher.
My Electrolux Kitchen app is available for
download from the app store on your
mobile device. You can scan the QR
code from the rating plate to be
redirected to the app (see chapter
"Product description").
The app is compatible with iOS and
Android operating systems. Check the
compatible versions of the operating
systems in the app store.
Wi-Fi module parameters
Wi-Fi mod‐
ule
NIUS-SA
Frequency 2.412 - 2.472 GHz
Protocol IEEE 802.11 b-g-n
Max Power <20 dBm
Encryption WPA, WPA2
7.1 How to connect the
dishwasher to the network and
to the app
To connect your dishwasher, you need:
• Wireless network with the Internet
connection.
• Mobile device connected to the
wireless network.
1. Launch My Electrolux Kitchen app on
your mobile device and follow the
instructions in the app. When
prompted in the app, activate the
wireless connection in the
dishwasher.
2. To activate the wireless connection,
press and hold simultaneously and
for 2 seconds.
• The indicator flashes.
• The display shows On for a few
seconds and then AP.
• All buttons are inactive except for
the on/off button.
3. When prompted, enter the home
network credentials in My Electrolux
Kitchen app.
If the credentials are not
entered, the dishwasher
cancels the procedure after
some time and returns to the
programme selection.
If the connection is successful, the
indicator is steady and the
letters AP are off. The appliance returns
to the programme selection. Refer to
"Daily use" to activate the remote start.
If the connection is
unsuccessful or the display
shows upd, refer to
"Troubleshooting".
If you want to cancel the procedure,
switch the appliance off and on.
7.2 How to deactivate the
wireless connection
Press and hold simultaneously and
for 2 seconds.
• The indicator is off.
• The display shows Off for a few
seconds.
• The appliance returns to the
programme selection.
7.3 How to activate the wireless
connection
Press and hold simultaneously and
for 2 seconds.
• The indicator is on.
• The display shows On for a few
seconds.
• The appliance returns to the
programme selection.
Refer to "Daily use" to activate the
remote start.
7.4 How to reset the network
credentials
If you want to connect to a different
wireless network or update the
credentials of the current network, reset
the network credentials.
Press and hold simultaneously and
for about 5 seconds.
www.electrolux.com16