What to do if my Electrolux EEWA7800 does not switch off?
If your Electrolux Kettle doesn't switch off automatically, ensure that you close the lid until it locks. Also, make sure that you insert the strainer correctly.
Why does my Electrolux EEWA7800 switch off before boiling?
If your Electrolux Kettle switches off before the water boils, it might be due to too much lime scale at the base. Run the decalcifying procedure to resolve this.
Miksi Electrolux-keittimeni sammuu ennen kuin vesi kiehuu?
Jos Electrolux-keittimesi sammuu ennen kuin vesi kiehuu, se voi johtua liiallisesta kalkkikertymästä pohjassa. Tee kalkinpoisto tämän ratkaisemiseksi.
How to fix an Electrolux EEWA7800 Kettle that cannot be switched on?
If your Electrolux Kettle cannot be switched on, it may be because it hasn't cooled down sufficiently after operating with little or no water. Allow it to cool for a short time, and then try again.
Covers warnings, general advice, and environmental information for appliance use.
Instructions for initial cleaning, base placement, lid operation, and filling.
Explains using controls, boiling water, auto shut-off, standby mode, and advanced features like temperature control and Keep Warm.
Steps for cleaning the kettle exterior, interior, filter, and base plate.
Guidance on how often and how to descale the kettle for optimal performance.
Lists typical problems with the kettle and provides step-by-step solutions.
Instructions on recycling packaging and disposing of electrical/electronic waste responsibly.
General| Capacity | 1.7 L |
|---|---|
| Material | Stainless Steel |
| Water Level Indicator | Yes |
| Cordless | Yes |
| Base | 360° Swivel Base |
| Auto Shut-off | Yes |
| Boil-dry Protection | Yes |
| Temperature Control | Yes |
| Keep Warm Function | Yes |
| Voltage | 220-240 V |
| Cord Length | 0.75 m |
To Next Page
