This option increases the
programme duration.
This option is not available
with a temperature lower
than 40 °C.
7.8 Permanent Soft Plus
Set this option to optimise the fabric
softener distribution and improve fabric
softness.
Recommended when you use fabric
softener.
This option increases the
programme duration.
The corresponding indicator above the
touch button illuminates and also stays
permanently on during next cycles until
this option is deactivated.
7.9 Permanent Extra Rinse
With this option you can permanently
have an extra rinse when you set a new
programme.
To activate/deactivate this option, hold
the Soft Plus button pressed for 3
seconds until the indicator
comes on/
goes off on the display.
When it is activated, the appliance will
default to this option after you switch it
off or change/reset the programme.
This option increases the
programme duration.
7.10 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric
creasing and facilitates the fabric ironing.
The corresponding indicator above the
touch button illuminates.
The indicator is steady on during
steam phase.
This option can increase the
programme duration.
When the programme stops the display
shows , the indicator goes off
and the indicator
and the Start/Pause
led are steady on. The drum
performs smooth movements for about
30 minutes to keep the steam benefit. By
touching any button the anti-crease
movements stop and the door unlocks,
the appliance proposes again the
previous set programme.
To interrupt the anti-crease phase, you
can also:
• Press the On/Off button for a few
seconds to activate or the deactivate
the appliance.
• Turning the programme dial in
another position.
A small laundry load helps to
reach better results.
7.11 Child Lock
With this option you can prevent children
from playing with the control panel.
To activate/deactivate this option, hold
the Plus Steam button pressed until the
indicator comes on/goes off on the
display.
When it is activated, the appliance will
default to this option after you switch it
off or change/reset the programme. If
you press any button, the indicator
blinks to indicate that the buttons are
disabled.
The Child Lock function may not be
available for a few seconds after
switching the appliance on.
7.12 Delay Start
With this option you can delay the start of
a programme to a more convenient time.
Touch the button repeatedly to set the
required delay. The time increases in
steps of 1 hour up to 20 hours.
The display shows the indicator and
the selected delay time. After touching
the Start/Pause button, the appliance
begins the countdown and the door is
locked.
www.electrolux.com22
To Next Page
Loading...
